This message was posted by KERRMINATOR on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/889.html#000010 Maybe if you try turning off the sensors in OS. See if it stitches ok past the first two stitches, then stop it and turn the sensors back on. This is located under tools> machine settings> un-check 'enable all thread detection' =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================