[amayausers] Re: Visors on XT driver
- From: "Wolf Embroidery" <wolfemb@xxxxxxxx>
- To: <amayausers@xxxxxxxxxxxxx>
- Date: Mon, 17 Apr 2006 16:14:31 -0400
I just did it last night.
Go to Tools, Hoop set up, custom hoop list. Just look in that drop down box
and apply.
Wolf Embroidery
Wolfemb@xxxxxxxx
Lisa and Don Ridley
----- Original Message -----
From: "Mike Garber" <agraphic2@xxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxx>
Sent: Monday, April 17, 2006 4:08 PM
Subject: [amayausers] Re: Visors on XT driver
> Anand,
> I think I was in hoop setup? There was a list of hoops not on the drop
> down list. I selected the XT WACF and its loaded. Sorry, I'm losing my
> mind. I'm not at my embroidery computer and I can't remember exactly
> how I did it......I'll reply again after I research my steps.
>
> Mike
>
> Kesavan wrote:
>
>>Where is the XT Extended?
>>
>>Thanks
>>
>>
>>
>>
>>OK, sewing hats with the WACF hoop selected on the XT machine will give
>>you burned bills....
>>The 'XT Extended WACF' hoop selection is not loaded on the drop down
>>menu. Once added to the hoop menu and selected the design cannot go as
>>low as the WACF hoop and no more hats rubbing. I knew it was me....
>>
>>Mike
>>
>>Mike Garber wrote:
>>
>>
>>
>>>Morning,
>>>
>>>Has anyone sewn a sportsman visor on the XT cap driver. I loaded one up
>>>an was able to sew closer to the brim which was exciting. The problem
>>>is the visor rubbed on the back of the needle bar and burned a big hole
>>>in it.
>>>
>>>The other thing I'm struggling with is unstructured hats are very loose
>>>and wrinkled on the machine. I think its the low needle plate. On the
>>>old machine I was able to get away with one piece of 4" tearaway on just
>>>a front design. The hat on the new machine has alot of loose material
>>>in front of the needle.
>>>
>>>Anyone?
>>>
>>>Mike
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.385 / Virus Database: 268.4.2/314 - Release Date: 4/16/2006
>
Other related posts:
