[amayausers] Re: Visors on XT driver
- From: Mike Garber <agraphic2@xxxxxxxxxxxx>
- To: amayausers@xxxxxxxxxxxxx
- Date: Mon, 17 Apr 2006 13:08:37 -0700
Anand,
I think I was in hoop setup? There was a list of hoops not on the drop
down list. I selected the XT WACF and its loaded. Sorry, I'm losing my
mind. I'm not at my embroidery computer and I can't remember exactly
how I did it......I'll reply again after I research my steps.
Mike
Kesavan wrote:
>Where is the XT Extended?
>
>Thanks
>
>
>
>
>OK, sewing hats with the WACF hoop selected on the XT machine will give
>you burned bills....
>The 'XT Extended WACF' hoop selection is not loaded on the drop down
>menu. Once added to the hoop menu and selected the design cannot go as
>low as the WACF hoop and no more hats rubbing. I knew it was me....
>
>Mike
>
>Mike Garber wrote:
>
>
>
>>Morning,
>>
>>Has anyone sewn a sportsman visor on the XT cap driver. I loaded one up
>>an was able to sew closer to the brim which was exciting. The problem
>>is the visor rubbed on the back of the needle bar and burned a big hole
>>in it.
>>
>>The other thing I'm struggling with is unstructured hats are very loose
>>and wrinkled on the machine. I think its the low needle plate. On the
>>old machine I was able to get away with one piece of 4" tearaway on just
>>a front design. The hat on the new machine has alot of loose material
>>in front of the needle.
>>
>>Anyone?
>>
>>Mike
>>
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
>
>
>
Other related posts:
