[THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
- From: "Andrew Wood" <andrew.wood@xxxxxxxxxxxxxxxx>
- To: <thin@xxxxxxxxxxxxx>
- Date: Thu, 7 Feb 2008 10:22:50 -0000
Hmm... didn't realize that.
This you mean? http://support.microsoft.com/kb/927695/en-us, or this
http://vittoriop77.blogspot.com/2008/01/nlb-tcp-reset-caused-by-receive-side.html
Or...
http://support.microsoft.com/kb/936594/en-us which describes a whole litany of
character building experiences.
-----Original Message-----
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of
Jolley, Eric
Sent: 07 February 2008 09:41
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
Andrew,
You're welcome! Let me know if you have any issues with that. The other
potential downside to the NetXtreme II NICs is when you install SP2 on 2003. It
contains the Scalable Networking Pack which can cause some strange network
problems. If so, the very latest drivers from HP should fix it. Or, you have to
disable receive side scaling.
Good luck!
----- Original Message -----
From: thin-bounce@xxxxxxxxxxxxx <thin-bounce@xxxxxxxxxxxxx>
To: thin@xxxxxxxxxxxxx <thin@xxxxxxxxxxxxx>
Sent: Thu Feb 07 02:29:27 2008
Subject: [THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
Thanks for that Eric.
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of
Jolley, Eric
Sent: 06 February 2008 20:03
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
That’s it. They also call it a monolithic driver. I’ve been using it
successfully with ADS on DL360 G5’s and DL580 G4’s for about 9 months.
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of
Andrew Wood
Sent: Wednesday, February 06, 2008 2:31 AM
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
OOOoOOoo I don’t know – I didn’t spot that one
I saw all the other drivers but didn’t notice the RIS one – I’ll check.
Thanks.
From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of
M
Sent: 05 February 2008 21:02
To: thin@xxxxxxxxxxxxx
Subject: [THIN] Re: PXE Boot to ADS/WDS for Compaq G5s
Hello Andrew,
Are the ADS drivers similar to RIS or Windows PE drivers ? (I use the HP Rapid
Deployment Pack myself so i am not 100% certain).
Have you been to the new ( awful - older compaq based one was far better ) HP
driver site for the DL360 G5 ?
Half way down the page is a driver update for RIS / Windows PE
"HP NC-Series Multifunction Drivers for RIS/WinPE"
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=uk&prodTypeId=15351&prodSeriesId=1121486&prodNameId=3288144&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-64e3bfc34a2742baa89aa98fb0
Sorry if they arent the same.
Matt
----- Original Message -----
From: Andrew Wood <mailto:andrew.wood@xxxxxxxxxxxxxxxx>
To: thin@xxxxxxxxxxxxx
Sent: Monday, February 04, 2008 8:30 AM
Subject: [THIN] PXE Boot to ADS/WDS for Compaq G5s
Hi,
Has anyone been able to successfully boot a Compaq G5 to an ADS/WDS
build?
Every driver I try comes up with a RAMDISK error – I’ve seen an article
that suggests using specific Broadcom II drivers but I’ve had no joy with that
either
Tia.
Andrew
Gilwood CS Ltd
Registered Office : 197 Leechmere Road, Sunderland, UK, SR2 9DL. No.
6099397 England
����b��I+hR{.n�+����� �&ޢ� �8�z�h�V�jب�j z� ��zZ0�)��i��0���zX���+��b���
************************************************
For Archives, RSS, to Unsubscribe, Subscribe or
set Digest or Vacation mode use the below link:
//www.freelists.org/list/thin
************************************************
Other related posts:
