Just had the same problem but with the blue, found there was arcing between the focus pin and G1 under the cap that is glued over the CRT pins. check if this cap is loose and if so remove, clean arc track and re silicone to CRT. Tony Saracco TCS ELECTRONICS 406 Andra Ct. Gilberts, IL 60136 tcselectronics@xxxxxxxxx ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, August 20, 2004 9:23 PM Subject: [TechAssist] Zenith PTV red goes out of focus > This PTV I changed the focus / screen block and it is still going out of > focus. Can a bad splitter make only one color go out of focus? I haven't > tried to switch focus leads. Can I switch the leads coming out of the > splitter into the focus block? > Al Marquardt > ampm@xxxxxxx > Al Marquardt Electronic Repair > 206 W Main > Girardville Pa. 17935 > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/