Hi would you believe that the manual is in the TAG001 generator If you need it I can send it to you. Barry Barrys TV barrystv@xxxxxxx 613 224 3406 fax 613 723 9670 0ttawa,Canada ----- Original Message ----- From: "Bill S" <billans@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, July 23, 2002 3:40 PM Subject: [TechAssist] Questions on hooking up Chipper checker > > Hi all > We got this new chipper checker in and are using it for initializing a CTC > 187 and learning about this at the same time. The instructions say to > ground either pin 2 or pin 1 (depending on who made the micro u 3101. I > found the instructions up to this point but now tried to go to the next > setup procedure and I got to be honest, I have not found it and am starting > to feel real stupid now. I'm not totally computer illiterate but am > starting to think I should have written the instuctions as it would be a bit > more easier to follow. Where else am I to look in the instructions? > Thanks > Bill Sorensen > New Life Video & Audio > billans@xxxxxxxxxxxx > - - - - - - - - - - - - - - - - - - - > > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/