Mike, I'm not sure what kit you mean, but I see nothing in the Mits site about it. This is a V10 chassis, you will likely have a number of bad caps, not nearly to the extent of the V11 sets, but we usually find a couple of dozen throughout the main boards on these. No good way to get a reliable fix but to do lots of resoldering and check the electrolytics, primarily the Nichicon and Rubycon polarized. Leonard G. Caillouet Service Manager Electronics World Gainesville, FL 352-332-5608 352-332-5668 (fax) ----- Original Message ----- From: <Ttkirkpat@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, December 06, 2002 4:54 PM Subject: [TechAssist] Mitsubishi model VS-4501R- vertical bounces > Vertical scanning is perfect- after hot will jump vertically and eventually > stop jumping. Replaced the filters in the vertical circuit, no change. Is > there a modification for this model like the VS6071 and others have to > correct this?? Did I overlook something else? Heating and cooling make no > difference and there is nothing loose. Thanks from Mike at the Video Center. > My e-mail is ttkirkpat@xxxxxxx > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/