Final fix....F401. Thanks John, easy when you know what you are looking for. -Ed- > From: John Mielke <maintv@xxxxxxxxxxxxx> > Organization: Main TV > Reply-To: techassist@xxxxxxxxxxxxx > Date: Wed, 13 Mar 2002 10:32:15 -0800 > To: techassist@xxxxxxxxxxxxx > Subject: [TechAssist] Re: Magnavox XS2552 C308 Chassis-25X608-00BB > > > Hi. If the H. out was shorted, suspect F401 to be open. It is a soldered-in > pico fuse just in front of the main filter (2.5 Amp). This set has > only one ground and that should be any of the big heat sinks. The standby > volts should come from the main regulator, pin 4 of the STR30130 should be > +16 volts when the TV is off. If not, check all the resistors around the > STR.... I hope that helps. John. > > Tel-Tek Electronics wrote: > >> Need Help; >> >> Set came in dead, found H/O shorted (Q502) and replaced. >> Replaced C431 (1uf/200volts) and C432 (100uf/200volts) Resoldered R504 and >> R525. >> Have 157 volts on main filter, but have no idea where my standby voltage is. >> I have no circuit for this, and do not do many Magnavox in this area. >> Have found a point marked start up voltage, but may not have correct >> reference to ground. (reads less than 1.2 volts) >> Have no relay click, and set is Still, basically DEAD. >> Any Magnavox "hot shot" that can point me in the right direction would be >> appreciated. >> >> Thanks; >> -Ed- >> >> Please Change the address in your Address Book >> >> Default. >> >> teltek2@xxxxxxxxxxxx >> >> Secondary........ >> teltek35@xxxxxxxxxxx >> >> Tel-Tek Electronics. >> >> ------------------------------------------ >> Make your TechAssist database better! >> Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >> ------------------------------------------ >> To UNSUBSCRIBE your email address, click here: >> mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >> Or send a BLANK email with unsubscribe in the >> SUBJECT field to the address above. > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.