i'm gonna try that. i get @#$% for reception here. of course 2 weeks of rainy cold weather and the buildings tween me and downtown may not be helping. ________________________________ From: Eric Neilsen Photography <ej@xxxxxxxxxxxxxxxxxxxxxxxxxx> To: pure-silver@xxxxxxxxxxxxx Sent: Sat, October 24, 2009 8:46:08 AM Subject: [pure-silver] Re: Off topic, Spot meter problem And for those that might still use an antenna to get reception for a TV, a small blast of WD 40 on the coaxial threads will give you a better longer lasting connection between you roof top and the TV. Eric Neilsen Photo 4101 Commerce Street, Suite 9 Dallas, TX 75226 214 827-8301 http://ericneilsenphotography.com SKype ejprinter ________________________________ From:pure-silver-bounce@xxxxxxxxxxxxx [mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of Eric Nelson Sent: Friday, October 23, 2009 1:44 AM To: pure-silver@xxxxxxxxxxxxx Subject: [pure-silver] Re: Off topic, Spot meter problem WD-40 works wonders on electrical contacts. Once I had an older TV in for repair and mentioned that when I turned the volume knob (see it WAS old!) it made a scratchy noise through the speaker. Repair guy told me to squirt some WD in there, I did, and no more problem. Same thing happened with a high end analog radio tuner I have. I don't know what exactly I squirted the WD onto, but it was something making electrical contact inside the unit when I opened it up and moved when I turned the dial. Turned it on and problem was fixed. Recently had a pull switch in the darkroom go "bad" and when I couldn't find a replacement in the house, I did squirted some WD in there and now it works fine. One doesn't need to use a lot. ________________________________ From:Tim Daneliuk <tundra@xxxxxxxxxxxxxx> To: pure-silver@xxxxxxxxxxxxx Sent: Tue, October 20, 2009 11:58:55 AM Subject: [pure-silver] Re: Off topic, Spot meter problem BOB KISS wrote: > Though I would not argue with Tim's experience, I would worry that > WD-40 might leave a film on the battery contacts that might be either an > insulator or, at least, cause some resistance...which may cause problems > with meter accuracy or battery life. Nope. WD-40 is just fine on battery contacts. It neither causes increased resistance of any significance nor - when used sparingly - is there all that much residue. WD-40 was invented as a water displacement and rust inhibitor. When used rationally, it is an excellent cleaner/lube in many contexts. There are probably some ultra high impedance situations where the film left behind might cause an undesirable current leak, but these are few and far between. As I said, I've resurrected all manner of dead/sick electronics - tube, transistor, FET, and IC - with an appropriate application of this magic juice to contacts, switches, potentiometers, and the like. > A better idea is to contact an electronics shop, especially an > Amateur Radio supplier (Google them) and purchase some "conductive > lubricant". It is both an excellent conductor and a rust inhibitor. This would also be fine BUT one has to be very careful. Under no circumstances would I recommend the use of "Contact Cleaner" type solutions. The solvents used in many of these are quite destructive to plastic. I've seen components and plastic mounting hardware melt under the onslaught of contact cleaner. ---------------------------------------------------------------------------- Tim Daneliuk tundra@xxxxxxxxxxxxxx PGP Key: http://www.tundraware.com/PGP/ ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.