----- Original Message ----- From: "PcCowboy" <saddle@xxxxxxxxxxxxxxxxxxx> To: <pchelpers@xxxxxxxxxxxxx> > >I plan to get the Optorite DD0401 > > > > > The 201 and 203 also uses HD-BURN. Didn't hear about the same for DVD. > Look closely, Look closely, I bet you see that the DVD will only play in the > 401 drive and not you home DVD player ***** Good Point, I'll look into this. I am really not to excited to go to all of this just to make CDs. Wife's [non-nerder] thinks it sounds great, but even with typical gear as DVD VCD VCR and other typical home electronics, we don't rent, or buy a dozen DVDs, VCRs in a years time. ***** > >In researching about installation, I seem to get the impression that this is > >an internal CD/DVD burner that will be put into the slot where OEM CD is now located. So, I gather that this is a replacement. Is this the right way to go, internal verses external? > Internal is the way to go for me. Unless the tech has changed an > external will be slower. If you have the slot for it I would leave the > OEM cd-drive in. Why wear out your DVD-drive by playing cds. Also the > DVD-drive will run better if you set it up as the Master. ***** Second good point, I'll check this out. I just looked at the front of my on the floor tower CPU. I see a curved plain panel just below the place where the OEM CD RW is installed that is about the same size. I'll check your good point further, tomorrow. ***** Lou Regards, John Durham (list moderator) <http://modecideas.com/contact.html?sig> Freelists login at //www.freelists.org/cgi-bin/lsg2.cgi List archives at //www.freelists.org/archives/pchelpers PC-HELPERS list subscribe/unsub at http://modecideas.com/discuss.htm?sig Good advice is like good paint- it only works if applied.