[modeleng] Re: copper tubes
- From: "I.D.PRIEST." <idpriest@xxxxxxxxxxxxxxxx>
- To: <modeleng@xxxxxxxxxxxxx>
- Date: Mon, 28 Aug 2006 22:29:37 +0100
Patrick,
Where do you live?
Regards IDP
"Life should NOT be a journey to the grave with the intention of arriving
safely in an attractive and well preserved body, but rather to skid in
sideways, Champagne in one hand - strawberries in the other,
body thoroughly used up, totally worn out and screaming WOO HOO - What a
Ride!"
"Never drive faster than your gaurdian angel can fly"
Priest & Sons Model Engineers
http://www.kinvermes.pwp.blueyonder.co.uk/p1.htm
----- Original Message -----
From: "Patrick Coppens-Marian Lynch" <develop@xxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Monday, August 28, 2006 2:56 PM
Subject: [modeleng] copper tubes
evnin' all,
If I wanted a Cu barrel tube, say 4 or 5 inch and about 15 inch long.
Where would I go, to get the either a piece of tube, or the plate to
make it.
In this godforsaken place, nobody seems to sell Cu-plate that is thicker
than 1mm,
or tubing that has an OD larger than 1 inch...
Thanks,
Patrick
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line.
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.11.6/428 - Release Date: 25/08/2006
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts:
