[modeleng] Re: copper tubes

I live in Flanders,Belgium
I.D.PRIEST. wrote:

>Patrick,
>
>Where do you live?
>
>Regards IDP
>
>"Life should NOT be a journey to the grave with the intention of arriving
>safely in an attractive and well preserved body, but rather to skid in
>sideways, Champagne in one hand - strawberries in the other,
>body thoroughly used up, totally worn out and screaming WOO HOO - What a
>Ride!"
>
>"Never drive faster than your gaurdian angel can fly"
>
>Priest & Sons Model Engineers
>http://www.kinvermes.pwp.blueyonder.co.uk/p1.htm
>
>----- Original Message ----- 
>From: "Patrick Coppens-Marian Lynch" <develop@xxxxxxxxx>
>To: <modeleng@xxxxxxxxxxxxx>
>Sent: Monday, August 28, 2006 2:56 PM
>Subject: [modeleng] copper tubes
>
>
>evnin' all,
>
>If I wanted a Cu barrel tube, say 4 or 5 inch and about 15 inch long.
>Where would I go, to get the either a piece of tube, or the plate to
>make it.
>In this godforsaken place, nobody seems to sell Cu-plate that is thicker
>than 1mm,
>or tubing that has an OD larger than 1 inch...
>
>Thanks,
>Patrick
>MODEL ENGINEERING DISCUSSION LIST.
>
>To UNSUBSCRIBE from this list, send a blank email to,
>modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject 
>line.
>
>
>
>  
>
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: