[modeleng] Re: Screwcutting

Even easier if you mount the cutting tool upside down & cut the thread at
the rear of the hole, it's much easier to see what's happening & no need to
reverse the motor.


-----Original Message-----
From: modeleng-bounce@xxxxxxxxxxxxx [mailto:modeleng-bounce@xxxxxxxxxxxxx]
On Behalf Of Ken Strauss
Sent: 25 November 2007 01:55
To: modeleng@xxxxxxxxxxxxx
Subject: [modeleng] Re: Screwcutting

It should be easy if you mount the cutting tool upside down and run the
lathe backwards.



MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: