Hi friends, i have a frame that monitors a line on the screen then if a number changes, it executes a script. when the text on the screen changes, it speaks the frame at the moment and I would like to turn this off so it says nothing but just launches the script. I have checked the frame properties but can't seem to find out the action, can anyone point me in the correct location please? i seem to remember that when i set up the script through the Wizzard, there was a selection of actions and one of them is screen echo or something and I can't find that now in the Frame viewer? ----------------------------------------------------------------------------------------- The information in this e-mail and any attachments is confidential and is intended for the attention and use of the named addressee(s). It must not be disclosed to any other person without our authority. If you are not the intended recipient, or a person responsible for delivering it to the intended recipient or are aware that this e-mail has been sent to you in error, you are not authorised to and must not disclose, copy, distribute, or retain this message or any part of it. We sweep all outgoing messages for the presence of computer viruses. However, we cannot accept any responsibility for any loss or damage to your systems due to viruses or malicious code not detected. The statements and opinions expressed in this message are those of the author and do not necessarily reflect those of the organisations within the Cornwall & Isles of Scilly Health Community. This email may be disclosed under the Freedom of Information Act 2000 or the Environmental Information Regulations 2004. ----------------------------------------------------------------------------------------- __________ Visit and contribute to The JAWS Script Repository http://jawsscripts.com View the list's information and change your settings at //www.freelists.org/list/jawsscripts