On 14 Aug 2006 Peter Bell <peter@xxxxxxxxxxxxxxxxx> wrote: > In message <44CC0F7D.6070300@xxxxxxx> > James Byrne <jbyrne@xxxxxxx> wrote: > > If that doesn't get you anywhere, try forcing the link speed to 100M > > and see if that helps. > > Can this be done on the running system, or is it only via the Configure > eklink command, to take effect on the next start up? An RMReinit should cause any new configure options to become active. > Has anyone any clues as to what is going on here? If an RMReinit will bring it back, it may well be the driver thats got itself in a funny state. Hardware issues tend to, but not always, need a soft reset. Cheers ---Dave -- ____________________________________________________________________________ David J. Ruck Phone: +44- (0)7974 108301 Email: druck@xxxxxxxxxxxx ____________________________________________________________________________ --- To alter your preferences or leave the group, visit //www.freelists.org/list/iyonix-support Other info via //www.freelists.org/webpage/iyonix-support