Thanks Blake, I'm pressing the right buttons but the NC Drill GUI does not pop up. I get the NCtape_full at the bottom of screen. Sam -----Original Message----- From: Moore, Blake <Blake.Moore@xxxxxxxxxx> To: icu-pcb-forum <icu-pcb-forum@xxxxxxxxxxxxx> Sent: Wed, Aug 29, 2012 8:19 am Subject: [PCB_FORUM] Re: [RMX:#] drill quit working. From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of sjchar3@xxxxxxxxxxxx Sent: Wednesday, August 29, 2012 11:02 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: [RMX:#] drill quit working. Im using allegro 16.3. At the bottom of the GUI I see "nctape_full". I brought in the NClegend and the vias were updated, but i don't have a "DRL" file. Thanks for all replies. -----Original Message----- From: TEYSSIER Jean-Charles <jcteyssier@xxxxxxxxxxxxxxx> To: icu-pcb-forum <icu-pcb-forum@xxxxxxxxxxxxx> Sent: Wed, Aug 29, 2012 6:10 am Subject: [PCB_FORUM] Re: [RMX:#] drill quit working. Some cheks : - no space in directory names. - Space disk left ? - No space in temp directory name Jean-Charles TEYSSIER De : icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] De la part de Matija Golar Envoyé : mercredi 29 août 2012 15:03 À : icu-pcb-forum@xxxxxxxxxxxxx Objet : [PCB_FORUM] Re: [RMX:#] drill quit working. i think it is more trivial... try entering ncdrill config and change 1 parameter, so config file gets rewritten, then start drill again i remember seeing something like this once... regards, Matija On 29.8.2012 14:55, isco catanyag wrote: Try to install latest hotfix. From: TEYSSIER Jean-Charles <jcteyssier@xxxxxxxxxxxxxxx> To: icu-pcb-forum@xxxxxxxxxxxxx Sent: Wednesday, August 29, 2012 2:09 PM Subject: [PCB_FORUM] Re: [RMX:#] drill quit working. Hi sam, Which allegro version and which symptoms ? Jean-Charles TEYSSIER De : icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] De la part de sjchar3@xxxxxxxxxxxx Envoyé : mercredi 29 août 2012 01:29 À : icu-pcb-forum@xxxxxxxxxxxxx Objet : [RMX:#] [PCB_FORUM] drill quit working. Group: Not sure what happened but the drill functions isn't working anymore. Any help would be appreciated. Thanks sam