[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing
- From: Paul_Keefe@xxxxxxx
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Fri, 27 Oct 2006 13:16:35 -0400
Ok, I hope I'm not the only one that can't figure this out but when I'm
in sourcelink/skill and do a search for 11022718 I get a nice description
of what to do but
it doesn't direct me to this RATA skill tool.
Thanks
I've been wondering for a few years why cadence doesn't do this without
any outside tool.
Paul
"Peter" <peter_pietrangelo@xxxxxxxxxxxxx>
Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx
10/27/2006 09:36 AM
Please respond to
icu-pcb-forum@xxxxxxxxxxxxx
To
<icu-pcb-forum@xxxxxxxxxxxxx>
cc
Subject
[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing
It is there. Solution # 11022718
Peter
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
gnieski_mike@xxxxxxx
Sent: Friday, October 27, 2006 6:02 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing
Unable to fine RATA on Sourcelink......is it a skill program?
Sourcelink if very time consuming at times.
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Weinberg, Richard
(Richard)
Sent: Thursday, October 26, 2006 6:10 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing
I use RATA
Cut and paste the stack up window into a paint program and save it as a
.bmp. RATA will change it into an .ipf file that can be imported into
Allegro.
Richard Weinberg
Member of Technical Staff
Telecom and Enterprise Networks Division
Agere Systems
(207)846-4539
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
toswanstrum@xxxxxxxxxx
Sent: Thursday, October 26, 2006 5:34 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Putting the cross section chart onto the fab drawing
Is there any way to easily put the information located in the cross
section chart into a detail on the fab drawing in an automatic way?
Thanks
Tom
Other related posts:
