[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing

I probably shouldn't do this, but see attached file
 

Richard Weinberg 



 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
Paul_Keefe@xxxxxxx
Sent: Friday, October 27, 2006 1:17 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing



   Ok, I hope I'm not the only one that can't figure this out but when
I'm in sourcelink/skill and do a search for 11022718 I get a nice
description of what to do but 
it doesn't direct me to this RATA skill tool. 

  Thanks 
I've been wondering for a few years why cadence doesn't do this without
any outside tool. 

Paul 





"Peter" <peter_pietrangelo@xxxxxxxxxxxxx> 
Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx 

10/27/2006 09:36 AM 
Please respond to
icu-pcb-forum@xxxxxxxxxxxxx


To
<icu-pcb-forum@xxxxxxxxxxxxx> 
cc
Subject
[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing

        




It is there. Solution # 11022718 
  
Peter 
  

________________________________


From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
gnieski_mike@xxxxxxx
Sent: Friday, October 27, 2006 6:02 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing 
  
    Unable to fine RATA on Sourcelink......is it a skill program?
Sourcelink if very time consuming at times. 
  
  

________________________________


From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Weinberg,
Richard (Richard)
Sent: Thursday, October 26, 2006 6:10 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing 
I use RATA 
  
  
  
  
Cut and paste the stack up window into a paint program and save it as a
.bmp. RATA will change it into an .ipf file that can be imported into
Allegro. 

Richard Weinberg 
Member of Technical Staff 
Telecom and Enterprise Networks Division 
Agere Systems 
(207)846-4539 
  
  
  

________________________________


From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
toswanstrum@xxxxxxxxxx
Sent: Thursday, October 26, 2006 5:34 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Putting the cross section chart onto the fab
drawing 

Is there any way to easily put the information located in the cross
section chart into a detail on the fab drawing in an automatic way? 

Thanks 

Tom

JPEG image

Other related posts: