[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing

It is there. Solution # 11022718

 

Peter

 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
gnieski_mike@xxxxxxx
Sent: Friday, October 27, 2006 6:02 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing

 

    Unable to fine RATA on Sourcelink......is it a skill program? Sourcelink
if very time consuming at times.

 

 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Weinberg, Richard
(Richard)
Sent: Thursday, October 26, 2006 6:10 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Putting the cross section chart onto the fab
drawing

I use RATA

 



 

 

Cut and paste the stack up window into a paint program and save it as a
.bmp. RATA will change it into an .ipf file that can be imported into
Allegro.

Richard Weinberg 
Member of Technical Staff 
Telecom and Enterprise Networks Division 
Agere Systems 
(207)846-4539 

 

 

 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
toswanstrum@xxxxxxxxxx
Sent: Thursday, October 26, 2006 5:34 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Putting the cross section chart onto the fab drawing

Is there any way to easily put the information located in the cross section
chart into a detail on the fab drawing in an automatic way?

Thanks 

Tom

JPEG image

Other related posts: