[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing

From: "Weinberg, Richard \(Richard\)" <rweinberg@xxxxxxxxx>
To: <icu-pcb-forum@xxxxxxxxxxxxx>
Date: Thu, 26 Oct 2006 18:10:00 -0400

I use RATA
 
 
 
 
Cut and paste the stack up window into a paint program and save it as a
.bmp. RATA will change it into an .ipf file that can be imported into
Allegro.

Richard Weinberg 
Member of Technical Staff 
Telecom and Enterprise Networks Division 
Agere Systems 
(207)846-4539 


 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
toswanstrum@xxxxxxxxxx
Sent: Thursday, October 26, 2006 5:34 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Putting the cross section chart onto the fab
drawing



Is there any way to easily put the information located in the cross
section chart into a detail on the fab drawing in an automatic way?

Thanks 

Tom

Follow-Ups:

[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing
From: gnieski_mike

References:
- [PCB_FORUM] Putting the cross section chart onto the fab drawing
  - From: toswanstrum

[PCB_FORUM] Re: Putting the cross section chart onto the fab drawing

Other related posts: