[elky] Re: Transmission dipstick question

  • From: Robert Adams <elcam84@xxxxxxxxx>
  • To: elky@xxxxxxxxxxxxx
  • Date: Sat, 12 May 2012 09:10:38 -0500

               Make sure you are using a 700r4 filter with that deep pan.
One of the problems with the 2004r is that the stock filter feeds from the
top and easily sucks air. The 700r4 filter feeds off the bottom. Even
running the 2004r a pint to a quart over full you still get pressure
fluctuations due to air getting in. One thing you can't do with a 2004r is
go backwards up a steep incline. It will suck air and slip badly.

                  And like Mike said the tube isn't seated in the trans.
You can see the bubble in the tube that seats against the cast aluminum.


                    Robert Adams

On Fri, May 11, 2012 at 10:17 PM, Ray Buck <rbuck@xxxxxxxxxxxx> wrote:

>  How far should the transmission dipstick extend into the tranny pan?
> Here's where the Monte Carlo's stick is when it's fully inserted:
>
>
>
> To get the ATF level up past the "Add" mark, the level of ATF (when
> running) would have to be above the pan/body join line.  I run an Art Carr
> deep pan with drain plug, so there's probably 4-5 inches between the bottom
> of the pan and the END of the dipstick...and the end is prolly 2 inches
> above the level of the filter.
>
> I've never been really sure about the reading on that stick and at one
> point, I had to add ATF cuz it just wouldn't move.  Obviously, it was low.
> But looking at this and combining the fact that the ATF and the bottom of
> the pan looked fine (no broken parts, no burned smell) I'm just wondering
> if the problem is just low ATF level.  I think I'm gonna put the pan back
> on and put the recommended amount of ATF plus 2 quarts to make up for the
> depth of the deeper pan...but any insight on this would be appreciated.
>
> In other news, I've ordered new long-tube headers, alternator and PS pump
> brackets and Chris is looking into a locking transmission mount for me.
> Oh...and a set of 2" drop spindles to get the nose of the car down.
>
> Progress is good, but now it's time for a bite to eat and bed.
>
> r
>
>

Other related posts: