Hi all, using Beta 3, Build Date: 24 May 2004. I'm just wondering if anyone else has got confused by the Embosser setup dialogue. 1. Choose Embosser Setup from either the Global or Document menus. 2. Press the New button and enter a setup name. 3. Choose an embosser, then press the OK button. 4. Control returns to the Setup dialogue, with the focus on the New button. at which point, the instinctive thing to do, is to tab through the rest of the dialogue setting the lines per page etc. Unfortunately, the selected setup is not the one just created, but the one that was selected when the New button was pressed. Put simply, the instinctive thing to do is change the settings for the wrong setup! Maybe it is more obvious to sighted users that the settings are about to be changed for the wrong setup, but for speech users I reckon it is too easy to make a mistake. Cheers. Ian * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *