Robert,
It sounds like the Condor had axial flow from top to bottom. I think what
Paul is suggesting is radial flow from inside to outside with a solid
bottom plate and a perforated side wall letting the flow out into a
surrounding chamber.
I think Paul's idea has a lot of potential. One issue with it is
pre-compressing the screens. With axial flow you can press them down with
a hydraulic press. How can you pre-compress the screens radially from
inside to outside?
Bob Steinke
On Fri, Sep 16, 2016 at 4:42 PM, <qbert@xxxxxxxxxxxxxxx> wrote:
That is the way the Condor cat pack was made except we injected from the
top. We tried center injection but the
peroxide never got to the outer screens so we went back to top injection.
No channel rings cause the screen
is tight against the wall of the catpack.
Robert
At 01:58 PM 9/16/2016, you wrote:
Now suppose that you build the cat pack as a hollow spool....
The Catpack material is rectangular (no waste) and is wound around the
spool...
The as the H2O2 goes from liquid at the center to Gas at the outside the
area of the cat pack increases
So one would expect a lower pressure drop. One can increase the length
of the tubular section without increasing
 the anti channeling area....Â
