[amayausers.com] Re: constant thread breaks
- From: Markus Schnetgoecke <shop@xxxxxxxxxxxxxxxxxxx>
- To: amayausers@xxxxxxxxxxxxx
- Date: Mon, 25 May 2009 18:42:30 -0700 (PDT)
Check your bobbin - does it drop about 6 inches when you test? Also the needle
plate may have a burr. Loosen the plate screws and put the head down to center
- adjust the plate so that the needle is in the center and tighten screws.
Check your acti feed and adjust higher if necessary.
--- On Mon, 5/25/09, theboards@xxxxxxxxxxxxxx <theboards@xxxxxxxxxxxxxx> wrote:
From: theboards@xxxxxxxxxxxxxx <theboards@xxxxxxxxxxxxxx>
Subject: [amayausers.com] Re: constant thread breaks
To: amayausers@xxxxxxxxxxxxx
Date: Monday, May 25, 2009, 5:07 PM
This message was posted by Debbie on AmayaUsers.com. PLEASE DO NOT REPLY VIA
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/2/945.html
I have changed all the needles thinking they were causing the thread breaks. I
am still getting constant breaks. I rethread and start again. Get about 15
stitches and it breaks again.
I have stitched this same design on my other brand machines w/ no problem. I
am doing burp diapers and have on 3 for the material type. Is not correct? I
couldn't decide what else would be like a diaper w/ ply center.
deb
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
