What is the category of the bridge pin? To show up it needs to be one of: KSNODETYPE_SPEAKER KSNODETYPE_HEADPHONES KSNODETYPE_LINE_CONNECTOR KSNODETYPE_SPDIF_INTERFACE KSNODETYPE_MICROPHONE KSNODETYPE_HANDSET KSNODETYPE_HEADSET_SPEAKERS KSNODETYPE_HEADSET_MICROPHONE If the category is KSCATEGORY_AUDIO, then the device will only show up if you go to mmsys.cpl and chose "show disabled devices". Regards, Mitch Rundle Microsoft Corporation ________________________________ From: wdmaudiodev-bounce@xxxxxxxxxxxxx on behalf of Nick Dowell Sent: Tue 8/29/2006 9:09 AM To: wdmaudiodev@xxxxxxxxxxxxx Subject: [wdmaudiodev] vista: not appearing as system audio device Hi, I've been trying out an avstream - based driver I'm working on with Vista Beta 2. After getting the driver to install and startup ok, I find that my device is not available as an audio device to the system. (KSStudio can reach my driver and stream to it without problems) Is it possible to get a debug log output from the system (similar to sysaudio!sysaudiotracelevel) to see what's going wrong? Regards, Nick ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.com/ ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.com/