Alvie directed me to the training manual which I will go over again, but in the meantime: I found the following electrolytics leaking on the board: C945: 470uf@35v C950: 470uf@35V C985: 47uf@16v C949: 470uf@63V Also changed the negative "7912" regulator IC933 with an OEM (seen this intermitt.bad before). Now: push power. Click, hear HV rustle up with immediate SD. Still... But,if I heat the PS area with my hot air gun and retry it: /Powered up with good picture./ So, me thinks there are still some bad lytics around there since heat triggered it to power on. Will advise... Phil Bader Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx Phil Bader wrote: >I flexed and tapped.Nothing. I entered the error codes display by >holding both AVX and power buttons at once with the set off. It did >power on with two rows of numbers. >I got a series of the same two error codes displayed: >10 50 10 50 10 50 in two rows. >Now, the "10" will show up for most all shut downs and really doesn't >mean much. The "50" code indicated there was a SD due to either excess >current in the +130 volts line/source or excess voltage. Other causes >for a "50" code would be accompanied by another code and these are the >only ones. So, I'm thinking to concentrate in the +130 volt source. Good >possibility in an older set is bad lytics. Thinking out loud here. >Phil Bader > >Philip Bader >Jan Phyl TV Inc. (estab. 1976) >3420 Recker Hwy. Winter Haven, Fl. 33880 >Fax (863) 299-8821 >email: tjanphyl@xxxxxxxxxxxxxxx > > > >al m wrote: > > > >>Did you check for bad solder? >>Al Marquardt >>ampm@xxxxxxx >>Al Marquardt Electronic Repair >>206 W Main >>Girardville Pa. 17935 >>----- Original Message ----- >>From: "Phil Bader" <tjanphyl@xxxxxxxxxxxxxxx> >>To: <techassist@xxxxxxxxxxxxx> >>Sent: Monday, April 18, 2005 4:54 PM >>Subject: [TechAssist] Hitachi 50ES1K, AP31 "shuts down" >> >> >> >> >> >> >>>Customer said the set shuts off. I pushed power. heard a click.then >>>another click. I unplugged all three anodes from the top of the fly and >>>covered the holes with tape.I inserted my HV probe in one hole and >>>powered it up. Measured about 25KV. After about 20 seconds, click, shut >>>down. Seemed it stayed on longer this time. I put back all the anodes >>>and the set has been on and working about 15 min. now.Looks pretty good. >>>Convergence seems OK.I guess I need some sym-cures on this chassis for >>>intermittant shut down. Hard to test this type of intermittant. >>>Phil Bader >>> >>>-- >>> >>>Philip Bader >>>Jan Phyl TV Inc. (estab. 1976) >>>3420 Recker Hwy. Winter Haven, Fl. 33880 >>>Fax (863) 299-8821 >>>email: tjanphyl@xxxxxxxxxxxxxxx >>> >>>----------------------------------------------------------------------------- >>>This Email List is Public. Remove: http://www.tech-assist.org/remove.htm >>>Lost Password: http://www.tech-assist.org and select "Login Problems?". >>>Appliance Repair List: >>>http://www.tech-assist.org/secure/tip/chatjoin.htm#app >>>Email Archives: //www.freelists.org/archives/techassist/ >>> >>> >>> >>> >>> >>> >>----------------------------------------------------------------------------- >>This Email List is Public. Remove: http://www.tech-assist.org/remove.htm >>Lost Password: http://www.tech-assist.org and select "Login Problems?". >>Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app >>Email Archives: //www.freelists.org/archives/techassist/ >> >> >> >> >> >> >----------------------------------------------------------------------------- >This Email List is Public. Remove: http://www.tech-assist.org/remove.htm >Lost Password: http://www.tech-assist.org and select "Login Problems?". >Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app >Email Archives: //www.freelists.org/archives/techassist/ > > > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/