Before you waste too much time on it, remove the lenses and check the tubes to make sure they are not burned. Bill Bill's TV Service Sulphur Springs, TX >From: "Shoreline Electronics" <jstielau@xxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Subject: [TechAssist] Re: Zenith proj. model#A50M91W1 >Date: Mon, 28 Oct 2002 19:48:47 -0500 > > >Buck, > > These sets are famous for leaks.....there is a kit from Zenith which >handles the problem. Call them for a repair kit ( should be free! >888-393-6484. A far as the shorted H- output fix. Hv block & fly are prob >OK. Inspect the CRT drive boards for burnt parts & shorted resistors. > > >--------------------------------------------------------------- >Text pasted from WinSTIPS 2.0 >http://www.ServiceSoftware.com >--------------------------------------------------------------- >ZENITH 9-1978 >Set Comes On With Sound But No Raster On Any Of The Tubes >Chambers Electronic Service >Replaced H V Block A-17196-05, Qx3200 And Crx3412 Restored High Voltage And >All Three Tubes Came On >--------------------------------------------------------------- >ZENITH 9-1978 >Video No Go - High Voltage Ok >Check R3244 / 8.2k And R3243 / 110k Both 1/2 Watts On 9-1978 Module >--------------------------------------------------------------- > >These are funky sets to work on.........kind of a bad place to start with on >projo's. Fix the sweep module....contain the leaks & you should be all set. > > >Jeff Stielau >Shoreline Electronics Repair >125 Beech Tree Lane >Westbrook, CT 06498 >860-399-1861 >860-664-3535 (fax) >jstielau@xxxxxxxx >----- Original Message ----- >From: "sterling pasher" <spasher@xxxxxxxxxxxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Monday, October 28, 2002 6:05 PM >Subject: [TechAssist] Zenith proj. model#A50M91W1 > > > > > > I wonder if anyone can help me as this is a new experience to me. Got a >call > > for a Zenith proj. today. he had sound but no picture, I found that the > > Horz Out was shorted. This was replaced, still the same. Upon inspection >we > > found oil from 2 of pic tubes had leaked out. My question (as I am not >that > > familiar with projs. as I have only seen 2 before) is ,are the tubes gone >or > > can the oil be replaced? Also if whatever caused the leak be repaired? >Also > > would this leak cause the Horz Out. to short? > > Buck Pasher > > Buck's TV > > Gander Newfoundland > > Canada > > 709-256-7738 (Fax & Phone) > > > > > > > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/