Jeff, I have had same problem after vert repair, someone suggested replacing the eprom.. and that took care of the problem.. I believe the 25B800 and the 27B800 use same IC..#483520988527 according to my notes.. Hope this helps Bob, Bobs TV Worcester, ma woodman1@xxxxxxxx Main 508-853-1482 Fax 508-853-1480 ----- Original Message ----- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Friday, March 26, 2004 5:45 PM Subject: [TechAssist] TA...NAP HD2717C101 27B800, no video..(was vertical prblm) > This set came in with the typical vertical problem..or so I thought.. > I repaired the vertical section by replacing the two resistors, R420, R445, D409, D445 and IC500 and > repaired my traces that lifted...I double checked all the traces and they are fine. > Then, I had blue screen with retrace. Found voltages off on CRT board. Found R50 on CRT open, no help. > Resistance across R53 was half what is should be. The other two resistors for the red and green measured > correctly, pulled the resistors and measured fine out of circuit so I replaced the IC TDA6106. > Now I have raster at all, no OSD, increase G2 and all I get is raster with retrace lines. > I checked my -13 and +13 source, they are fine. I replaced the vertical IC again and no change. > Any ideas? > Thank you. > > Jeff Dougherty > Intrepid Video TV/VCR > 263 S Front St > Steelton PA 17113 > fax...717-564-4952 > www.intrepid-video.com www.tech-repair.net > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/