This set came in with the typical vertical problem..or so I thought.. I repaired the vertical section by replacing the two resistors, R420, R445, D409, D445 and IC500 and repaired my traces that lifted...I double checked all the traces and they are fine. Then, I had blue screen with retrace. Found voltages off on CRT board. Found R50 on CRT open, no help. Resistance across R53 was half what is should be. The other two resistors for the red and green measured correctly, pulled the resistors and measured fine out of circuit so I replaced the IC TDA6106. Now I have raster at all, no OSD, increase G2 and all I get is raster with retrace lines. I checked my -13 and +13 source, they are fine. I replaced the vertical IC again and no change. Any ideas? Thank you. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/