Hello . Remove HOT collector pin. Look if you have 135v. If not trace down to rectified diode.check components and continuity. Good luck Dang TD electronics www.tvcrcomputers.com reseda , CA 91335 ----- Original Message ----- From: <ERNtv@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, August 29, 2003 7:49 AM Subject: [TechAssist] Sony KV27XBR37 low or no secondary voltages > The power supply in this set will not develope the 134V off of pins 1 & 2 of > T604 but there is 13V on pin 5 of that same transf. I have isolated the horiz > circuit out so that isn"t where it is pulling down. At this point I am open > for any advice besides a stick of dynamite!!! > Thankyou > Scott Williamson > Ernies TV, Inc > Loveland, Co > 970-667-2424 > 970-203-9825 Fax > > > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/