Sent you some stuff on the CTC203..See if anything in there to help you out. -Ed- Ed Gaidies Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ----- Original Message ----- From: "Harry Sutton" <suttontv@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, August 18, 2003 10:03 PM Subject: [TechAssist] RCA CTC 203 will not start, no 12 volt source > Set clicks 4 times but will not start. No 16.5 volts in on U14104. Voltage > on collector of Q14105 is about 16 volts, base goes high when switched on, > Q14104 base is 15.9, emmitter is 16.7 but no collector voltage. Changed > U14104, Q14105, Q14104, and checked resistors in this circuit. Please advise > if anyone has seen this problem. > Harry Sutton > Sutton's Radio & TV > 982 Baker Chapel Church Road > Mt. Olive, NC 28365 > 919-658-2837 > suttontv@xxxxxxx > > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/