Keith there's an easier way to reset the gemstar using remote press menu, guide+ setup, 1, goback, input, clear the display will go off then back on in setup mode this clears all customer setup info and solves some intermittent issues Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Keith Trumbla" <keith@xxxxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, April 14, 2004 11:07 AM Subject: [TechAssist] Re: GE (rca) Model 27GT630 chassis CTC203AA9 no video > You can reset that gemstar module by removing it from the set and taking the > board out of it's metal case. There is a backup cap/battery (.047f or > something like that) that is used for memory retention. Take it out of > circuit and discharge it through a 4.7 ohm resistor. Make sure it reads zero > volts before you re-install it. When you power up the cap will recharge > itself. > HTH > Keith Trumbla > BEM Electronics > Suite 212-530 Century St. > Winnipeg Canada > R3H 0Y4 > Ph.204.775.2875 > Fax.204-774.9192 > www.bemelectronics.com > ----- Original Message ----- > From: "Shoreline Electronics" <jstielau@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, April 13, 2004 7:40 PM > Subject: [TechAssist] Re: GE (rca) Model 27GT630 chassis CTC203AA9 no video > > > > L14401 is base drive for your HV/H sweep........if that was a problem > you'd > > have no raster or HV. > > > > In tuner mode do you have snow? > > > > Kinda sounds like a Gemstar issue. > > > > ========================== > > Jeff Stielau > > Shoreline Electronics Repair > > 344 East Main Street > > Clinton,CT 06413 > > 860-399-1861 > > 860-664-3535 (fax) > > jstielau@xxxxxxxx > > ======================== > > "If you push something hard enough it will fall over." > > Fudd's First Law of Opposition - Sir Sidney Fudd > > > > > > ----- Original Message ----- > > From: "Alvin Rose" <ajroseca@xxxxxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Tuesday, April 13, 2004 11:54 PM > > Subject: [TechAssist] GE (rca) Model 27GT630 chassis CTC203AA9 no video > > > > > > > Hi Guys > > > We have a CTC-203AA9 chassis with no video..In the video audio mode.. > > > the sound is ok but on the screen it says unusable signal..Checked the > > > coil L14401 but it is not unsoldered and can find no bad solder joints > > > Any help would be appreciated > > > Alvin Rose > > > Radio & Tv Centre > > > Marystown, Nl > > > > > > > > > > > > > -------------------------------------------------------------------------- > > --- > > > Lost Password: > > > http://www.tech-assist.org and select "Login Problems?". > > > Email Archives: > > > //www.freelists.org/archives/techassist/ > > > > > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/