Either the mode switch is still defective or it is not in the eject position. If it tries to load without a cassette and then goes to eject, the prism may be broken or the end sensor may have a bad connection. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 Fax/Phone 864 232 3889 greentron@xxxxxxx ----- Original Message ----- From: "John H Smit" <SMIJOH74@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, January 20, 2005 11:02 PM Subject: [TechAssist] Emerson TV/VCR EWC1901 TV shuts off after 10 seconds > Hello to all > I have this TV/VCR Emerson TV/VCR, and the customer tore a stuck tape out of > the unit. > I have repaired the basket and aligned the VCR part. > But when I turn the set on it will show a good picture, and sound but it > will click off in about 10 seconds. > And it shows eject on the screen. > I cleaned and lubed the modeswitch. > I suspects the 5 or 12 volts missing at the front buttons,but do not have > the S/M available. > I hope someone could give me a hint on this one. > Thank you in advance > John H Smit > Smit's TV Service > Box10 > Gunnison Utah 84634 > 800-355-4948 Phone&Fax > 435-528-7955 Phone&Fax > smijoh74@xxxxxxxxxxxx > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/