Hi John, Common part failures on these sets: Center LED mounted on board under the deck, Mode switch and the sensors on either side of the deck assy. Also you may have a broken prism caused by customer pulling the tape out. Dave Huston Huston TV & Electronics 2846 Marion-Cardington Rd.E. Marion,Oh 43302-8919 Phone/Fax: 740-389-5726 email: HustonTV@xxxxxxxxxxxxxx ----- Original Message ----- From: "John H Smit" <SMIJOH74@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, January 20, 2005 11:02 PM Subject: [TechAssist] Emerson TV/VCR EWC1901 TV shuts off after 10 seconds Hello to all I have this TV/VCR Emerson TV/VCR, and the customer tore a stuck tape out of the unit. I have repaired the basket and aligned the VCR part. But when I turn the set on it will show a good picture, and sound but it will click off in about 10 seconds. And it shows eject on the screen. I cleaned and lubed the modeswitch. I suspects the 5 or 12 volts missing at the front buttons,but do not have the S/M available. I hope someone could give me a hint on this one. Thank you in advance John H Smit Smit's TV Service Box10 Gunnison Utah 84634 800-355-4948 Phone&Fax 435-528-7955 Phone&Fax smijoh74@xxxxxxxxxxxx ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/