=20 Hi, I was going through a layout for differential signals, when I noticed that the stub for the termination from the receiver was as long as 500 mils or so. I thought if used at a high frequency this should matter. Kindly let me know your views. Will this stub affect timing, is it required the match the p and n lengths of the termination stub too? Thanks and warm regards, Vani The information contained in this electronic message and any attachments to= this message are intended for the exclusive use of the addressee(s) and= may contain proprietary, confidential or privileged information. If you= are not the intended recipient, you should not disseminate, distribute or= copy this e-mail. Please notify the sender immediately and destroy all= copies of this message and any attachments.=20 WARNING: Computer viruses can be transmitted via email. The recipient= should check this email and any attachments for the presence of viruses.= The company accepts no liability for any damage caused by any virus= transmitted by this email. =20 www.wipro.com ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu