Hi All
With the LPDDR4
Is CE the signal used for any ACC Training?
(I read through the JEDEC spec where that there is only mention of using CE
when writing trained values into Mode registers )
Since the CE is always high, should it be a part of Simulation while
simulating in Hyperlynx
Or can that be left out from ACC bunch
If you include the VREF level is pushed up and I am seeing violation in ACC.
With the same setup if it is omitted no violations observed In Eye Mask.
Thanks
Madhu
::DISCLAIMER::
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended
for the named recipient(s) only. E-mail transmission is not guaranteed to be
secure or error-free as information could be intercepted, corrupted, lost,
destroyed, arrive late or incomplete, or may contain viruses in transmission.
The e mail and its contents (with or without referred errors) shall therefore
not attach any liability on the originator or HCL or its affiliates. Views or
opinions, if any, presented in this email are solely those of the author and
may not necessarily reflect the views or opinions of HCL or its affiliates. Any
form of reproduction, dissemination, copying, disclosure, modification,
distribution and / or publication of this message without the prior written
consent of authorized representative of HCL is strictly prohibited. If you have
received this email in error please delete it and notify the sender
immediately. Before opening any email and/or attachments, please check them for
viruses and other defects.
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu