Why don't you check the [Pin] syntax. In case of BGA or CGA, the package made by user has some alphabetic character in their pin number. But AB01 is not same as to AB1, Good luck Inmyung -----Original Message----- From: si-list-bounce@xxxxxxxxxxxxx [mailto:si-list-bounce@xxxxxxxxxxxxx]On Behalf Of marko.pulli@xxxxxxxxx Sent: Saturday, February 16, 2002 3:53 AM To: si-list@xxxxxxxxxxxxx Subject: [SI-LIST] ICX problem with part model load and no pin model Hi all, I'm having problems when loading a part model into ICX. What could be the reason when no pin models appear on pin model column after a part model has been loaded? When probing a net on this pin it will show higher steady state output = than VCC and also lots of over/under shoot :-) It works ok and I get meaninful results if I load a pin model separately = for each pin. I think ICX should do this automatically but I'm doing something wrong = here.. -Marko ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu