[SI-LIST] Re: EXT :Re: Ferrite Beads
- From: "Shimko, Steve (ES)" <s.shimko@xxxxxxx>
- To: "tgsmith81@xxxxxxxxx" <tgsmith81@xxxxxxxxx>, "si-list@xxxxxxxxxxxxx" <si-list@xxxxxxxxxxxxx>, "leeritchey@xxxxxxxxxxxxx" <leeritchey@xxxxxxxxxxxxx>
- Date: Mon, 7 Dec 2015 12:29:22 +0000
We usually put a source termination resistor, 22 ohms to 33 ohms, at the output
of the clock oscillator, or even some other active device that may be receiving
the clock from an external source. This helps match the output impedance of
the oscillator or other device to the (nominally) 50 ohm signal trace.
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx [mailto:si-list-bounce@xxxxxxxxxxxxx] On
Behalf Of Tim Smith
Sent: Sunday, December 06, 2015 9:58 PM
To: si-list@xxxxxxxxxxxxx; leeritchey@xxxxxxxxxxxxx
Subject: EXT :[SI-LIST] Re: Ferrite Beads
On 12/6/2015 8:07 PM, Lee Ritchey wrote:
Why would one deliberately degrade a signal that way?
I have inherited this design; however I imagine that it was done in an attempt
to slow the edges of the clock signal in an effort to reduce the higher
frequency components.
I recall one of your seminars Lee where you recommend to keep edges slow.
If the clock signal is to be used by a PLL internal to the MCU, is not the best
signal to deliver a sine wave?
Whilst I appreciate the intention of the previous designer, I don't believe
using a potentially resonant circuit is the correct way to go about it.
On Mon, Dec 7, 2015 at 1:41 PM, Kevin G. Rhoads <krhoads@xxxxxxxxxxxxxx>
wrote:
On 12/6/2015 8:07 PM, Lee Ritchey wrote:
Why would one deliberately degrade a signal that way?
It was stated several posts back that it was intended to control the
edge rise time by that ...
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
Other related posts:
