I wonder if the 'puzzle piece' flooring is the best idea? (assuming it is wall to wall?) Why do you want this? What are the properties you want from the floor? I recently had a drain blockage which backed up and flooded into the floor of our kitchen/breakfast room. This was covered with heavy duty carpet tiles which fitted tightly like puzzle pieces and were also stuck down to concrete in places. They had rubber backing I thought at the time that there seemed little penetration through these rubber backed tiles (about a couple of feet square each) as the 'flooding' was not severe - more of an ooze across the floor. However, insurers sent a team to estimate whether they could be cleaned as opposed to my request to replace. They took them all up and disposed of them, pointing out that seepage between tiles caused water to then get under the rubber - and we have now had a heavy duty pro dehumidifier working 24/7 for 3 weeks and the concrete still hasn't dried enough to put new covering down. In my darkroom I chose seamless thick cushion vinyl flooring. This is kind to the feet and waterproof. It is sealed around the walls and spillages are easy to deal with. I can also roll about on a castor chair, which is useful in long sessions and when Lith printing with long dev times - kind to the feet:-) It is very easy to clean too and it doesn't hold dust. These are all the properties I wanted from my darkroom floor. It has worn well for many years now Tim -----Original Message----- From: pure-silver-bounce@xxxxxxxxxxxxx [mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of Adrienne Moumin Sent: 11 January 2005 15:02 To: pure-silver@xxxxxxxxxxxxx Subject: [pure-silver] Darkroom Mats and Party Hats Wow, more good info, thanks all! I was thinking about the rubber smell from the mats, too, the ones where I work & also at the gym I belong to don't smell but maybe they've been around awhile. I'm familiar w/the playground puzzle-piece ones I've seen in many places, but I don't think they're as thick. I'll begin to check around (and SNIFF around!!) & expect that as usual, I'll find more choices than my brain can absorb! Like you, Dave, I sprung for the extra dinero for GFCI's on all outlets. The enlarger is on its own circuit to protect against power surges from other stuff. Over the past year or so I've pulled a ton of info off this list about voltage loads, etc., to figure out how to spec out the new circuits when we did an upgrade to the 60-year old fuse system we had. The party hats are for the celebration once this baby's done...I'm drooling with anticipation! -Adrienne *************************************** Please, please shake some booty on the dance floor. You look great in those pants and we totally spy you tapping your foot up against the wall, flower. If the beat moves you, then rock it. from "nonsense nyc," 12/31/04...and their list of rules for New Year's Eve (and for life). ============================================================================ ================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.