Wilfried, I really do like the design of your boiler. Have you gotten to the point that you can steam test it? Al Messer --- Wilfried Vermeiren <vermeiren.wilfried@xxxxxxxxx> wrote: > > > -----Oorspronkelijk bericht----- > Van: modeleng-bounce@xxxxxxxxxxxxx > [mailto:modeleng-bounce@xxxxxxxxxxxxx] > Namens Charles & Dorothy Brumbelow > Verzonden: woensdag 11 januari 2006 12:31 > Aan: modeleng@xxxxxxxxxxxxx > Onderwerp: [modeleng] Re: bandsaws > > > Hi, > Well it was just one of these idea's which stuck me > whilst working. And in > my view tooling has to be as simple as possible and > if I can adapt an > existing machine to my needs I would rather buy, I > know, I know, the base > and work from thereon. > If you would follow the idea make sure the head of > the machine can swivel > both ways of vertical. Most of the machines have a > fixed head or only > movable in one direction. > Must admit however that although the machine works > well, did the whole set > of mills at that time, it has seen little use since. > The world changed a bit and since then regret not > much activity in the > workshop, at least not ME, but an update is in the > making about a "new" > sideway. > Regards > Wilfried Vermeiren > http://users.skynet.be/modelbouw.wilfried > > origineel bericht/ > > You've got quite a nice web site, Wilfried! Thanks > for sharing. I found > the conversion of a chain saw sharpening grinder > into an end mill sharpener > especially ingenious. Charles > > > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email > to, > modeleng-request@xxxxxxxxxxxxx with the word > "unsubscribe" in the subject line. > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.