[minima] Re: Ver.0.030 code problems
- From: "Clyde Hyman" <zs1cs@xxxxxxxxxxxx>
- To: <minima@xxxxxxxxxxxxx>
- Date: Sun, 30 Mar 2014 09:55:40 +0200
Please how can I unsubscribe to minima groups, I am having problems with my
Email hanging up.
Thank you.
Clyde ZS1CS
----- Original Message -----
From: Frank
To: minima@xxxxxxxxxxxxx
Sent: Saturday, March 29, 2014 7:52 PM
Subject: [minima] Re: Ver.0.030 code problems
Jerry,
I use a Mac, you know I believe Thomas also uses a Mac. I wonder if you have
hit on something.
Frank - W4NHJ
-
On 3/29/14, 1:14 PM, jerry@xxxxxxxxxxxxxxxx wrote:
Frank, thanks for sending the files, I will compare the code to mine.
What operating system do you run your Arduino software with? Jerry
K5LRU
Harwood, Texas
-------- Original Message --------
Subject: [minima] Re: Ver.0.030 code problems
From: Frank <w4nhj@xxxxxxxxxxx>
Date: Sat, March 29, 2014 11:03 am
To: minima@xxxxxxxxxxxxx
Jerry,
I tested my digital board with the V0.03 firmware and it works. I could
send you the three files I have and you can see if that works. Perhaps
something was changed in the firmware that is on Github now, but I doubt it.
Frank - W4NHJ
-
On 3/29/14, 11:34 AM, Celso - PY2XT wrote:
Hi Jerry and folks,
I have the same problem with my digital board, just like you.
I will continue researching and wait for help from more experienced friends.
73 to all.
Celso - PY2XT.
De: jerry@xxxxxxxxxxxxxxxx
Enviada: Sábado, 29 de Março de 2014 07:02
Para: minima@xxxxxxxxxxxxx
Assunto: [minima] Ver.0.030 code problems
I bought a new si570, built a new digi-board, and guess what, I still
have the same problem. The si570 is frozen at 56.3 Mhz. I got a test
sketch from Mac (I put my callsign in the code to make sure I was
pulling up the right file through Arduino) see attachment, and I am able
to change the frequency of the si570 with the sketch which proves the
I2C bus is working OK. The chip puts out a clean signal at around 2.84v
peak to peak, (see attachments). With Farhan's original sketch, the
si570 will tune. I think I've read everything there is on the internet
about the I2C buss, and I don't think that's my problem, unless it is
running too fast with the new version code. I made my own digi board
pcb, but it was from Adrian's design, so it should be the same as
everyone else. The voltages on the si570 are at 3.274. I'm out of ideas.
I need help. Jerry
K5LRU
Harwood, Texas
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
Other related posts:
