M bit confused abt 47k or 4K7, till I have PCB in my hand... anyways thanks 4 correction note... On 05/02/2014, Sandeep Lohia <sandeeplohia12@xxxxxxxxx> wrote: > We might skip this cutting also (see attachment) > > By installing 4.7 K inside Header connector wire ( wire which connects > both boards) See T/R or PTT. > > > > > > On 05/02/2014, Leonardo Ramirez <ea7kb@xxxxxxxxxxx> wrote: >> I had to add a 47k resistor and works well, with 4.7k with the Atmel >> remained in TX. >> >> 73. >> >> >>> Date: Wed, 5 Feb 2014 20:53:16 +0530 >>> Subject: [minima] Re: Resistor in main board pcb >>> From: sandeeplohia12@xxxxxxxxx >>> To: minima@xxxxxxxxxxxxx >>> >>> Thanks Leo -EA7KB >>> >>> There's a jumper on PIN 5 of Arduino (digital board), hope we can >>> replace jumper with 4.7K resistance (only if PTT still works)... >>> >>> Otherwise we need to cut a small trace ( with surgical hobby knife or >>> shaving blade) scratch remove green-solder-resist-mask & install 4.7 K >>> on back side of MAIN PCB. >>> >>> >>> >>> On 05/02/2014, Leonardo Ramirez <ea7kb@xxxxxxxxxxx> wrote: >>> > Hi guys. >>> > In Main board pcb must be added the base resistance of q23 . >>> > Regards. >>> > >>> > Leo / EA7KB >>> > >>> > >>> > >>> >>> >>> -- >>> -- >>> Please encourage recycling, reuse or repairing of E-waste. >>> ░7░3░ ░d░e░ ░V░U░3░S░X░T░ >>> >> > > > -- > -- > Please encourage recycling, reuse or repairing of E-waste. > ░7░3░ ░d░e░ ░V░U░3░S░X░T░ > -- -- Please encourage recycling, reuse or repairing of E-waste. ░7░3░ ░d░e░ ░V░U░3░S░X░T░