[duxuser] Re: dbt and everest embosser
- From: "George Bell" <george@xxxxxxxxxxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Sat, 20 Jan 2007 19:16:04 -0000
Hi Armando,
If you have a binding margin of 3 cells, and 30 cells per
line, you will have to allow for 33 cells in total per line.
Try reducing your characters per line to 28 or 29.
Likewise, if you have a top margin a 3 lines and wish to
print 26 lines, you will need to allow for a total of 29
lines.
George.
________________________________
From: duxuser-bounce@xxxxxxxxxxxxx
[mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Armando
Maldonado
Sent: 20 January 2007 19:08
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] dbt and everest embosser
Hello Members,
I'm using dbt 10.6 with an everst embosser version II. For
some reason, I cannot get dbt to work properly with the
embosser. What happens is that the page number appears on
the second line rather than on the right side of page, and
the braille goes over the margin. I have set the embosser to
characters per line at 32, left margin, b margin, top margin
and bottom margin all to zero. The lines per page is set at
26. In DBT, I have it set to the following: characters per
line, 30, binding margin 3, top margin 1, right most
placement cell at 32. If you can please tell me what I need
to change in order for the two to communicate properly, this
would be appreciated. Thanks.
Armando
Other related posts:
