[ddots-l] Re: latency question
- From: Bryan Smart <bryansmart@xxxxxxxxxxxxxx>
- To: "ddots-l@xxxxxxxxxxxxx" <ddots-l@xxxxxxxxxxxxx>
- Date: Thu, 2 Sep 2010 21:08:16 -0400
Omar,
#1. In Sonar, check to see if pause mode is enabled. You toggle it with the
pause key on your keyboard. When it is on, Sonar can play with lower latency,
but it is slower to respond to controls like play and stop.
#2. Check your picture cache folder. If you've been using Sonar for a while,
you may have many of these...too many. Feel free to erase every file in that
folder.
Do either of these suggestions help?
Bryan
-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On
Behalf Of Omar Binno
Sent: Thursday, September 02, 2010 3:10 PM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Re: latency question
Gord,
Hypersonic, dr008, and v sampler are just a few. the latency isn't necessarily
only during recording. anytime i hit a key it's not playing immedietly. i know
it's not the fault of any of my audio interface settings.
----- Original Message -----
From: Gordon Kent <mailto:dbmusic@xxxxxxxxxxxx>
To: ddots-l@xxxxxxxxxxxxx
Sent: Thursday, September 02, 2010 2:59 PM
Subject: [ddots-l] Re: latency question
Omar:
What synths are you loading? If you are experiencing latency whe
recording you may need to invoke the latency compensation function with control
d while recording. Remember to take it off when you're done or your newly
recorded tracks will not play in sync.
Gord
----- Original Message -----
From: Omar Binno <mailto:omarbinno@xxxxxxxxx>
To: ddots-l@xxxxxxxxxxxxx
Sent: Thursday, September 02, 2010 2:24 PM
Subject: [ddots-l] latency question
Hello,
I notice that when i load more synths into an existing project,
i start getting latency when playing. in a new project there's no latency. i'm
assuming this starts happening in an existing project because of the amount of
audio tracks there? Is there a way to deal with that latency?
Thanks.
OMAR BINNO
WEBSITE: www.bigoproductions.net
AIM: LOD1116
SKYPE: obinno1
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subjectúq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
Other related posts:
