Uninstall CT. then, delete that file. Then reboot the system again and input
your CT registration details when installing. That should work :-)
On 26 October 2015 20:56:53 GMT+00:00, Laurie Cannon <simp749@xxxxxxxxxxxxx>
wrote:
Phil,
Well, I downloaded the executable and now I have a different problem,
before
I even get to the control surface. When I try to reinstall CT 8.8.51
from
the executable, I get an error that it can't open the Sonar8.5ct88.ini
file
in the personalized settings under the app\roaming\jaws\11\settings\enu
directory. Says it can't oen the file, maybe the disk is full or no
access.
The hard disk is not full and I am an administrator. I tried
unchecking
read-only on the personalized settings and I tried running the
executable as
an administrator. Any ideas?
Thanks!
Laurie
_____
From: ddots-l-bounce@xxxxxxxxxxxxx
[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On
Behalf Of Phil Muir
Sent: Monday, October 26, 2015 4:37 PM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Re: New installation of Caketalking 8.8, control
surface
not enabled.
You are very welcome! Think that will fix it :-)
On 26 October 2015 19:42:32 GMT+00:00, Laurie Cannon
<simp749@xxxxxxxxxxxxx>
wrote:
Phil,
Thanks, I'm going to try a reinstall using the downloaded executable
instead
of the dvd.
Thanks again!
Laurie
_____
From: ddots-l-bounce@xxxxxxxxxxxxx
[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On
Behalf Of Phil Muir
Sent: Monday, October 26, 2015 5:49 AM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Re: New installation of Caketalking 8.8, control
surface
not enabled.
Sounds as if something funky may have happened with the CT install. May
be
worth reinstalling CT.
On 26 October 2015 08:56:29 GMT+00:00, Laurie Cannon
<simp749@xxxxxxxxxxxxx>
wrote:
Hello,
I just got Sonar 8.5.3 up and running on a computer new to me and I
installed Caketalking 8.8 which I got from Dancing Dots. I'm using
Jaws 11
on a Windows 7 64-bit system. When I start Sonar, I can't get a track
view
because the Caketalking control surface will not enable. When I type
Ctrl/f12, and press enter, I get the error message that the control
surfaces
dialog cannot be opened. What have I missed or what could be wrong?
Do I
need to start everything over in 32-bit mode? Any help greatly
appreciated.
Got to get a project out the door and I'm stuck!
Thanks!
Laurie
--
Regards,
Accessibility Training
Telephone: UK +44-1747-228-459
Mobile: UK +44-7968-136-246
E-mail:
info@xxxxxxxxxxxxxxxxxxxxxxxxxxx
URL:
http://www.accessibilitytraining.co.uk
