If I recall correctly, so did you, and not a word was spoken! >>> clarence@xxxxxxxxxxx Tuesday, February 08, 2005 3:59:32 PM >>> HMMM. I think I remember you putting away a 24 ounce steak in New = Jersey=20 without ever laying down the knife and fork. That was a sight. <grin> At 03:53 PM 2/8/2005 -0500, you wrote: >Hey, how about my dinner? =3D20 > >Humm, a good steak sounds yummy! > > > >>> clarence@xxxxxxxxxxx Tuesday, February 08, 2005 3:35:07 PM >>> >Thanks for that, and I was wrong; it does make a difference which cost = =3D >me=3D20 >having to buy Robert dinner. > > >At 03:21 PM 2/8/2005 -0500, you wrote: > >You can go to Tools/Options in Internet Explorer and under the Advanced = =3D >=3D3D > >Tab, there is a setting under Security that says Allow Active Content = on =3D >=3D3D > >my PC. Set that to "On", and you should be set. > > > > > > >>> r-carter@xxxxxxx Tuesday, February 08, 2005 3:10:40 PM >>> > >Hi All, > > > >After installing Windows xp service pack 2 with its enhanced = security,=3D3D2=3D >0 > >whenever I open the Book Port manual on the pc, I get a message saying = =3D >=3D3D > >that=3D3D20 > >internet explorer has blocked part of the content to protect me. I have = =3D >=3D3D > >to=3D3D20 > >right click on this and tell IE to allow the entire file to be loaded. = =3D >=3D3D > >I=3D3D20 > >have to do this each time I open the manual. Does anybody know any way = =3D >=3D3D > >to=3D3D20 > >make this change permanent so as not to have to go through it each = time? > > > >Thanks, > > > >Robert Carter > > >Clarence Whaley >Training Division Manager >GW Micro >E-Mail: Clarence@xxxxxxxxxxx=3D20=20 >Direct Voice (615) 383-6248 >or 866-699-8901 >Direct Fax (260) 489-2608 >GW Micro Voice Number 260-489-3671 >http://www.gwmicro.com=3D20=20 >or press enter below to read all about our training program >http://www.gwmicro.com/training =3D20 Clarence Whaley Training Division Manager GW Micro E-Mail: Clarence@xxxxxxxxxxx=20 Direct Voice (615) 383-6248 or 866-699-8901 Direct Fax (260) 489-2608 GW Micro Voice Number 260-489-3671 http://www.gwmicro.com=20 or press enter below to read all about our training program http://www.gwmicro.com/training =20