This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/704.html#000008 It will depend on what level of software that you have to be able to "Convert to Wireframe". To do this , if it is available to you, choose the element you are working with in the "Project Tree" on the right side of your screen, look for "Convert Object to Wireframe" and click on it. This element is now in an OFM, CND format and can be editited acordingly. If you choose an element in the project tree, right click on it and the "Convert to Wireframe" is greyed out, then your software version level is not high enough and you may have to digitize the piece again like Roland has suggested. Be careful about just converting your entire design to wireframe. Going through any conversion process like this may/can/will change fill patterns, etc. Always work on a duplicate of your original design and not your original, so you will have it to fall back on if you make changes that don't work out. Resaving a converted exp, dst, etc does not bring pack the original pattern that may have been in a fill....if the conversion changed it. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================