[amayausers.com] Re: adjusting pull compensation
- From: webmaster@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Mon, 29 Sep 2008 15:38:45 UT
This message was posted by djames on AmayaUsers.com. PLEASE DO NOT REPLY VIA
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/2/704.html#000010
With an expanded design, you can do some scaling to the design in the scale
properties tab. Down at the bottom you can change the fill density (higher
number means more stitches), fill stitch length and walk/underlay stitch
length. You can also change your column fill density. This is in pro+. Not
sure of the other levels.
Rod is right about converting the entire design to wireframe and how it can
change the fill patterns and densities etc. Remember you can select just an
element to convert also rather than the whole design.
Debbie
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
