[amayausers.com] Re: Thread shredding just above needle
- From: theboards@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Thu, 17 Jun 2010 15:14:27 UT
This message was posted by Chris & Cindy on AmayaUsers.com. PLEASE DO NOT REPLY
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/969.html#000006
Clean the bobbin case. Change the needle and turn the needle slightly more to
the right of center.
I had a tech show me this trick and it works great.
The specs say no more than 5% turn. This is only true when the machine is
properly adjusted. I have turned as much as 15% to stop shredding. The
shredding may be coming from the hook hitting the thread dead center. Turning
the needle can stop this most of the time. Turn it a little bit several times
or until the shredding stops.
Good Luck
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
