This message was posted by signman on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/969.html#000003 when I see the shredding it is 90% certain the needle has a 'burr' on it...run the tip of scissors 'down' the needle tip around it, if you feel a 'click' then your needle is toast. Usually we get that after doing 6 panel hats-the center seam 'pulls' the needle sideways as the needle goes into the needle plate and it just bends it a bit. After that-burr city! And every once in awhile do a 'head down' and double check the needle plate-seems the screws don't hold it in perfect alignment forever and it can shift just enough so the needle with thread 'rubs' on the way through, more shredding. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================